Search results

thanks cjacek

Hey all, I just needed a little bit of clarification on cassette tape types. I recently acquired a Yamaha MTX 8 deck, and had questions regarding chrome tape. Is all high bias type II tape "chrome" tape, or is chrome high bias type II tape slightly different? According to the manual...

Hello fellow tascamheads, I've hit a dead end recording and cannot find my manual, so maybe someone can help. I'm using a mackie mixer to phantom power my condenser mic, and then i've plugged in a tube preamp from the mixer to my tascam 424 mkII. I'm using the sub inputs, but I do now...

trying to get cep 2.0 to be used with my tascam 428. Do i need a patch or is capability built in already to 2.0? what happens if i try using both the usb and soundcard, or can only one be used at a time?

Hey, I live in a lower flat that I need to contain sound to an extent in, so as not to get evicted due to neighbors calling the cops. The upstairs neighbor is the landlord who is cool with the music. The problem is about 6-8 feet next door in a separate house. The room initially will be a...

"So you're going to use the Dano for clean, but the Twin for the heavy stuff? I sure don't get that. To me, a Twin is what you get when you need clean, but you need it really loud." I'll be using both, but the twin is going to hae a hot plate on it so I'll be able to crank it without killing...

Hello all! I've broken the bank on a couple of vintage amplifiers (a Fender 75 twin 135 rms, and a 65 danelectro dm25)..i'll be using these in an A/B setting using the dano as clean and mid-distortion, and the twin for all beyond. I'm looking for a rocking, affordable (less than $700-$800 lets...

I recently bought an Art Tube mic preamp. We were doing a recording session and didn't have a properly rated power supply for it, so I used it anyway (foolish I know!) and after 12 hours of use I burned something out. The preamp wont power up at all. The MP is 9v AC and is rated at 700 mA...

I am using a friends Marshall Jcm2000 amp head, and I can't get either of the two 4/8 ohm speaker outputs to work. The single 16 ohm output from the head works fine, but I have a THD hot plate which is 4 ohms which I would like to be using and can't at this moment. What might be wrong? Where...

Alright, i've been learning about this stuff for the past few months. I know how to read a schematiic, and i dug somewhat into variations of different component types, etc. What are some books that will best lead me from this point? and are there any books out there that deal more with...

Thanks so much Light and Easychair! And easychair is right, you seem to be at least a novice on the subject. I'm the amateur here, but if i get a couple more hundred of my questions answered the way you guys just did I might move up a notch :) Thanks again!

In reading an article on Amp output stages at: http://www.aikenamps.com/SingleEnded.htm I came across a few questions. If anyone could further explain to me what a "center-tapped primary" is? the context its used in is "in a push-pull amp the power supply is connected to the center-tapped...

i have no rack hooked up to my mixer. the set up is a) one condenser mic b)the mackie mixer and c) my studio monitor headphones ...so somewhere in here, i assume it is the mixer picking up the radio frequency. it seems to me there must be something cheaper than a $75 fix to cut out this...

the only thing i can thing of now is maybe building some sort of enclosure around the mixer that would block this frequency? i dont know what would do it however, research time! at least yours isn't country twang though, ha.

somehow i'm pretty sure my mackie 1202 vlz mixer is picking up a radio frequency and i dont know what would be causing it. i had a condenser mic plugged into it to try and record some acoustic guitar and i noticed through my headphones that a rather twangy country station was coming through...

Rick - i have started Paul Woodlocks IMMENSE and entertaining studio diary. Thank you for sharing that resource. I see I have quite a bit of reading to do, to say the least. Better to get deep enough into before ever starting construction It sounds like you don't have much knowledge on the...

Please keep in mind with these questions that theoretically this studio will be handbuilt by me, in a house that I will have also built, so no existing structures need to be dealt with-so in other words any suggestions can be thrown out here. What are some of the things that have large...

through london power press there are some techincal books by kevin o'connor. they seem to be very thorough and expensive. i was wondering if anyone had any one of these that they would be willing to loan to me for a couple weeks or a month. i would be willing to send jack darr's guitar amp...

if anyone could help me out i'm looking for analog mixer schematics and/or plans preferrably at least 8 channels, any era just quality. I'm also trying to get an idea of cost for this project. Any literature on the topic that someone could reccommend would be great too.

i'm looking into various studio monitor headphones, and so far the sony mdr 7506 headphones seem to be the most reccommended pair, but i guess i'm not content to go with that just yet. if anyone wants to share their experiences with studio monitor headphones - what has worked/hasnt... i'm...