Recent content by Cudmasters Los

How do you change the tempo of a imported song. The whole song, not parts of it. I know you can do it with groove clip looping, but that is only for a few seconds. If i change the tempo number it doesn't work.I can't seem to do it with audio snap, just notes. Thanks

Does anybody know what the best software is to build proffesional speaker boxes. 2 way's 3 way'. Bi ampables, subs, etc? Also what is used, like speaker gasket tape etc? Thanks

I am trying to find out what motherboard I can use that supports a 939 socket, AMD 64 3000+ and has an agp, and at least 2-3 pci slots, if not I will use the PCIE. that is under $75. I just bought the Asus A8V and found out later that it does not work. Can anybody help me? :confused:

I am looking for a rackmountable headphone amp in which I can plug the mix in from the back, and also have 6 to 8 outputs(independant) out the back as well, this is to send a signal to a vocal booth and a live recording room as well. Any suggestions on units?

Installing Audio Cables Through Double Wall near electrical outlet 1) I have electrical outlets in my double wall, (studio has its own power) where audio cables will be passing through. Will this pick up noise, and if so, would incasing the wires work, or what other suggestions do you guys...

I have a seperste console room, live room and vocal room. What should I use to enable the live room and the vocal room access to hear the control room. I have 2 outputs on my mixer, I have 3 dual jack wallplates for headphones that i am going to install. should I use seperate headphone amp's; 1...

What is it about the the tube pre amp that everyone says to get? Because it warms up the sound, is it really that different, or is it just the name. Should i go that route or not? Any thoughts?

I am recording straight into the computer, and i am wondering if i should get a tube rackmount for warm sound. If so i was looking into the beringer 1953 tube ultragain. I am on a low budget and was wondering your thoughts. Thanks

I can never get my music that I burned on a cd to sound like it does in my studio:( :confused: :( :confused: :( :( I am using sonar and Live Drive II, Creative sound card(SoundBlaster) playing thru a 32 behringer mixer to KRK V6 monitor speakers. This song I am recording sounds like a platnum...

Ever since I have installed Sonar, the projects that I made on PA9 are being pulled up by Sonar? How do I stop that and let each use its own unless I tell it too? :confused:

Right now I have the Live Drive II, but I'm tired of recording 1 track at a time. I am thinking of buying the echo Layla because I have 2 Adat's and this peice of hardware has not only 8 outputs, but a lightpipe also to work with the Adat's if I need to. I am working with Cakewalk, Acid, and...

Which Sound Card To Buy Layla, Delta, Difidesign, Motu ??? Right now I have the Live Drive II, but I'm tired of recording 1 track at a time. I am thinking of buying the echo Layla because I have 2 Adat's and this peice of hardware has not only 8 outputs, but a lightpipe also to work with the...

I have 6 outputs from the proteus 2000 sound module going to channels 3-8 on my mixer, vocals on 1&2. I then bus to the 8 subs, which go to my patch bay. I patch to my 2 Adats, worth 16 tracks to record. I playback to channels 9-24 on my mixer. I then compress thru the main insert point and...

I have a Eurodesk(Behringer) MX3282 mixer. The pan pots are very noisy when you turn them up. There is a very large hssss added to the tracks. Any suggestions as to how to eliminate this very annoying sound that is destroyong the quality of my tracks?

I have a 32 channel beringer and a couple of adats, outboard gear, keyboard an mpc 2000, and 2 KRK monitor speakers. Sometimes if i touch a 1/4" plug on the mixer or touch the back of the mpc 2000, i get a vibrating jolt of electricity. Does anybody have any advice on what to do and what is...