VR800 and Tascam TM-D1000?

  • Thread starter Thread starter kevio
  • Start date Start date
K

kevio

New member
Anyone have the VR800 and Tascam TM-D1000? I can't get this combo working yet. I have a IF-TAD converter also. What "word", "Sync", "slave", "master" settings should I make on each? The IF-TAD is flashing meaning that both units are in slave or master mode. I have tried it with and without the "word" connector. I am using a standard video BNC connector for the word cable. Any tips would be totally great.
Thanks,
Kevin
 
Ok, I got it working. I had to buy a BNC to RCA converter and connect the Word output on the IF-TAD to the RCA Word input on the TM-D1000. The VR800 is talking through the Fiber Optic cables which are going into the IF-TAD. The last cable in the connection is the TDIF cable from the TM-D1000 to the IF-TAD. Then I had to make the VR800 the master and the TM-1000 the slave. If anyone needs specifics on word settings and such just shoot me an email.
Kev
 
You must log in or register to reply here.
Back
Top