miribilist
New member
My Band and I were recently given a Trident 36 channel mixing desk out of a studio in London which has been collecting dust for the last few years.
We want to give it a home in our studio, but being totally new to old analogue desks have some (probably very basic) questions....
Im going to try and attach images to this post... there should be 5 i think.
The desk I think is a Trident 65 series 24bus console. Any information on this at all will be gratefully received.
We have no power supply and the little badge that gives the model, serial and power requirement info is totally faded and unreadable. Can someone recommend where we might source a replacement or newer power supply that might be better for the job?
Also, there is a large patch bay on the right hand side of the desk. ***NOOB QUESTION ALERT*** What is this area of the desk for?
We obv will need to connect headphones to the desk, but labeled on the back is a 56 pin multi plug. How would we go about connecting regular cans to this type of connector ie, what is the device that bridges this gap???
I think that’s all for now. Essentially all we want to da at this point is clean the thing up and just see whether it works for now. More dumbass questions to follow no doubt!!
Thanks for your help and patience in advance ☺ Andy
We want to give it a home in our studio, but being totally new to old analogue desks have some (probably very basic) questions....
Im going to try and attach images to this post... there should be 5 i think.
The desk I think is a Trident 65 series 24bus console. Any information on this at all will be gratefully received.
We have no power supply and the little badge that gives the model, serial and power requirement info is totally faded and unreadable. Can someone recommend where we might source a replacement or newer power supply that might be better for the job?
Also, there is a large patch bay on the right hand side of the desk. ***NOOB QUESTION ALERT*** What is this area of the desk for?
We obv will need to connect headphones to the desk, but labeled on the back is a 56 pin multi plug. How would we go about connecting regular cans to this type of connector ie, what is the device that bridges this gap???
I think that’s all for now. Essentially all we want to da at this point is clean the thing up and just see whether it works for now. More dumbass questions to follow no doubt!!
Thanks for your help and patience in advance ☺ Andy