TASCAM 388 Studio 8 F4 fuse problem

  • Thread starter Thread starter jpwag
  • Start date Start date
Status
Not open for further replies.
J

jpwag

New member
I recently acquired a TASCAM 388 studio 8. Mixer works fine but the play, record, ff, rewind functions are all dead. I replaced the blown F4 fuse with a new one. As soon as I turn the power on the F4 fuse heats up and blows again. I'm using a slowblow 3A250V as indicated on the Fuse PCB.

Any ideas? I'm no electronics wiz, so appreciate any help. Thanks in advance.
 
Welcome aboard.
I have a 388 too,but have'nt had any fuse problems with it yet,so Im not sure I could help you.But I could suggest posting this in the Analog forum,as there are a lot of 388 users and questions over there.
 
Status
Not open for further replies.
Back
Top