Cubase 5/ Tascam US-1641 Click Track problem - please help!

[corrado15]

Hi All,

Been drumming for 20+ years, recording MIDI with Reason for the past 5 and have recently bought a 1641 to mic up my drums and record through Cubase 5.

No issues setting it up or recording until it comes to the metronome/click track. When listening to recordings through my laptops speakers via generic asio driver, I can hear the click track fine. Whenever I switch to the 1641, I can hear my recorded track but not the metronome/click track. All settings other than the switch in driver remain the same.

Anyone have any ideas? The 1641 has the latest (64bit W7) drivers and firmware and the same problem is evident when using the Cubase 5 LE that was bundled with the 1641.

The laptop is a recent dual-core HP with decent RAM and HDD speed.

Going to post this in the Tascam forum too - hope that doesn't break any rules...

Thanks in advance,

Davy.

 

[corrado15]

Never mind - updated the drivers (which I could have swear I had done 3 weeks ago) and all is good.

 

[Chili]

Glad you figured it out. Something similar to this was driving me crazy for about a week. There's a little check box that needs to be selected in the VST Connections Output page. So, if it happens again, look at that.

peace,

 

[corrado15]

Thanks for the reply. Yeah I was good with the VST connections since it was fine through the laptop speakers. All's well that ends well.

Off topic - are you Irish? I am, though now living in PA.

Davy.

 

[Chili]

Yeah, irish-american. Never been to Ireland, but someday I will.

 

[jus_tin4]

Just wanna comment on an unrelated matter to cubase, Im Irish and our government is stupid!