paddedcell
Doggy Claws
My studio is still going through birth pangs -- its downsides are that it's small (about 6' x 9', with a 7' ceiling), and I haven't got anyplace to use for isolation (yet). Its upsides are that it's really well-insulated, and everything pretty much fits into it (as long as I put it on one leg at a time). It's based around a 2488, and I have Audax M08 monitors. I run my keyboards into a Soundcraft M4 board which then runs into the 2488 where I can assign the signal to whatever channels.
Here's my problem. I need to record vocals (other than my own), and I have to do them in this room. That means the monitors get muted, and the headphones go on. The 2488 has one headphone output, and I need at least two. I'm inclined to run the vocal mic directly into the 2488, rather than through the Soundcraft board, to avoid any signal degradation or added noise. (Am I being overly cautious about that?)
Any ideas about how to get multiple headphone monitors from the 2488, or the Soundcraft board?
I concede that I may be overlooking the obvious. . .I tend to do that sometimes. . .
Greg
Here's my problem. I need to record vocals (other than my own), and I have to do them in this room. That means the monitors get muted, and the headphones go on. The 2488 has one headphone output, and I need at least two. I'm inclined to run the vocal mic directly into the 2488, rather than through the Soundcraft board, to avoid any signal degradation or added noise. (Am I being overly cautious about that?)
Any ideas about how to get multiple headphone monitors from the 2488, or the Soundcraft board?
I concede that I may be overlooking the obvious. . .I tend to do that sometimes. . .
Greg