JohnnyAmato
New member
Hello, I looked around for a while and could not find specific answers to this. Sorry if it's been answered before and I just didn't find it yet.
When using the Slate VMS (Virtual Mic System) in the VMR, you obviously have the mic choice first, then into whatever preamp you choose. My question is this; should I insert the VTM before this? And where would the VCC go in the same VMR instance, after the preamp? Then I'll use one of the Slate EQs for boosting whatever needs it, and sometimes Revival.
After the VMR, I then use the ProTools EQ for roll offs (hi and low passing). Should this also be before the mic, before the "boosting" EQ in the VMR?
Last, I like the Waves CLA-76 and CLA-2A compressors a lot on my vocals, so I insert them last, and then finally a de-esser.
Am I doing this right?
Hopefully I posted this in the right section.
When using the Slate VMS (Virtual Mic System) in the VMR, you obviously have the mic choice first, then into whatever preamp you choose. My question is this; should I insert the VTM before this? And where would the VCC go in the same VMR instance, after the preamp? Then I'll use one of the Slate EQs for boosting whatever needs it, and sometimes Revival.
After the VMR, I then use the ProTools EQ for roll offs (hi and low passing). Should this also be before the mic, before the "boosting" EQ in the VMR?
Last, I like the Waves CLA-76 and CLA-2A compressors a lot on my vocals, so I insert them last, and then finally a de-esser.
Am I doing this right?
Hopefully I posted this in the right section.