Roland SRV-3030

  • Thread starter Thread starter longsoughtfor
  • Start date Start date
longsoughtfor

longsoughtfor

Searching for the sound
Hi - does anyone else use the Roland SRV-3030 reverb unit? I picked one up thinking I could get two separate channels in and out of it but so, far I have not been succesful in getting it to work in that mode.

The manual states that it has an "individual" mode (along with stereo etc...) but whenever I set it like that, I always get the same reverb out of both channels.

I'm hoping that I am doing something wrong.

Thanks
Kevin.
 
I just got this unit , and was wondering if you could do this as well. Does anyone have a clue? I've checked the owner's manual but didnt find anything specific...
 
Sorry about that... it was such an old post I wasn't sure it was still relevant to anyone. You have to create a preset for each channel seperately, but I'm not sure if you can use them both at the same time. If you find a preset you want to edit, hit "custom" and enter "structure". First, set the structure to "Individual". Then scroll to find the Unit Input/Output and set one of the channels to off. This preset is now for one individual channel. If you want to try using two channels separately, you would have to use one preset and enter "custom" and "structure", then set structure to "Individual" as well. But this time, reenter "custom" and set Reverb A and B to whichever reverbs you prefer and each channel should respond separately. Good luck!
 
You must log in or register to reply here.
Back
Top