Preamp problem, or sucky mixer?

  • Thread starter Thread starter antispatula
  • Start date Start date
antispatula

antispatula

Active member
I just got a mixer. It's old. It has a built in preamp. I was wondering why I was getting so much white noise from simply having all the faders at halfway, with nothing plugged into any of them, Then I realized all the pre's were at 50%! So I turned them down, and didn't really have a prob with it anymore. But then I noticed that if I DID have something plugged into a channel, and then turned the pre anywhere past like 60%, I'd get a crappy buzzing sound. So I was wondering: Is the crappy buzzing coming from

A. Cheap built-in preamp

or

B. Is the preamp simply adding gain to an already crappy signal?

What do you think? I've got a Peavey board, and peaveys are supposed to be pretty quiet.
 
antispatula said:
But then I noticed that if I DID have something plugged into a channel, and then turned the pre anywhere past like 60%, I'd get a crappy buzzing sound. So I was wondering: Is the crappy buzzing coming from

A. Cheap built-in preamp

or

B. Is the preamp simply adding gain to an already crappy signal?
Click to expand...

Hard to say. What's the input? Is the buzz a 60 Hz hum?
 
If you get noise from the preamp with nothing plugged in (when you turn up the gain/trim), then it's most likely noisy preamps. Now, when you plug your gear in and get a buzz, it's either noise from the gear or bad electrical grounding (either in your home or within the unit, possibly). Are your house outlets properly grounded?
 
You must log in or register to reply here.
Back
Top