Omni Studio Problem

[OBCD]

Hey y'all...

I just bought an omni studio with the Delta 66 on E-bay.
Installed everything on WinXP Pro. So far, so good but here's the problem....

When I plug my bass in port #1 on the omni, I can see it's picking up the signal, but the goddamn meters on the Delta66 control panel won't budge! Same thing for #2.

And you know what? When I plug my tape deck in line in #3, the meters on the Delta control panel show activity. Everything is set up as they suggest it in the manual but I can't pick up anything trough Mic/Inst inputs #1 and 2.

Can someone tell me what the f*ck is goin' on?

I have an IBM model 300PL if that can help.
Thanks to everyone who chips in a little help.
I'll keep searching the posts for an answer...

 

[Rhythmsavant]

What are you using for your recording sw? You will need to route the ins and outs on the Delta CP , and also set your recording software to get the sound from the Omni Box...in Cool Edit Pro for example you have a record in box on each channel to select where its getting the audio from...
the inputs show up as Input 1/2 R & L, and Input 3/4 R & L, which are inputs 1,2,3,4 respectively

does that make sense?

re-reading your post it sounds like in the "routing/patchbay" section of the Delta CP you only have 3/4 selected under HW ins...try clicking 1/2 in the first row, and 3/4 in the second

 

[OBCD]

got it!

Finally solved the problem, it was the switches in the back of the omni. Sigh.

Once again I underestimated the amount of information and experience that has already been posted on these forums.
I wonder...since when has this board been runnin'?

 

[Rhythmsavant]

Re: got it!

Finally solved the problem, it was the switches in the back of the omni. Sigh.

Once again I underestimated the amount of information and experience that has already been posted on these forums.
I wonder...since when has this board been runnin'?

cool, those switches can cause problems...once i had to rewire half a patch bay before i realized i had one pushed in...