B
bonemix
New member
I am new to MIDI - call me a M-IDIOT-haha-
In my guitar rack i control a pre-amp and then Q-verb with a floorboard type controller. I am able to configure the MIDI table in the Q-Verb to translate the MIDI command and have it call up the appropriate Q-Verb patch. All is good.
But now i've added another MIDI device downstream from the Q-Verb. I have set the the 'MIDI THRU' to on. The next page to come up on the Q-Verb is 'SysEx' - i have that set to 'No'. the next page is a MIDI Table that should translate the 'MIDI Thru' command to the third device but when i try to adjust it and hit 'STORE (save)' it will not save the translation. the table remains '1 to 1', if you will.
This is the oldest of all Q-Verbs (it has no large shuffle knob).
Any help is appreciated.
Thanks
In my guitar rack i control a pre-amp and then Q-verb with a floorboard type controller. I am able to configure the MIDI table in the Q-Verb to translate the MIDI command and have it call up the appropriate Q-Verb patch. All is good.
But now i've added another MIDI device downstream from the Q-Verb. I have set the the 'MIDI THRU' to on. The next page to come up on the Q-Verb is 'SysEx' - i have that set to 'No'. the next page is a MIDI Table that should translate the 'MIDI Thru' command to the third device but when i try to adjust it and hit 'STORE (save)' it will not save the translation. the table remains '1 to 1', if you will.
This is the oldest of all Q-Verbs (it has no large shuffle knob).
Any help is appreciated.
Thanks