Help with panning in Reaper

[Mr. Cachi]

Hello everyone, when I try to hard pan two mono guitar tracks, reaper just lowers the volume on one side (even when panned 100%, you can still hear the track on the oposite side). The master track is in stereo, and I´ve tried all panning modes, without success. Has this happenned to any of you?

 

[VomitHatSteve]

Is there something wrong with your monitoring chain maybe? e.g. is there interference on your headphone cable?

Is your OS doing any audio processing? A lot of times, Windows et al will add some reverb and other stereo effects to on-board audio.

Do you see the meters on the channel showing a signal on the side you're panned away from?

 

[bouldersoundguy]

Do you have any parallel effects (e.g. a shared reverb bus) on the guitars?

 

[gecko zzed]

If you solo the track, does this still happen? Make sure yo don't have 'solo in front' turned on. Also, mute any effects any where.

 

[TalismanRich]

When I peg Reaper left or right, it goes 100% left or right. When I have a send to a reverb bus, I hear the reverb only on the opposite channel. If you are hearing sound in the opposite channel, you have something turned on somewhere that is feeding both sides.