display mode

  • Thread starter Thread starter alanray
  • Start date Start date
A

alanray

New member
hi! i really like my vf-16 but i jus have one problem: i can't seem to get the display mode to work in hours/min/sec/ect mode. i use it in bar/beat display, but i don't do midi stuff so it isn't a good measure of time for me. whenever i switch it to real time mode, it always stays on 0 min, 0 sec ect. and doesn't seem to move with the song.... anyone know anything about this?
thanks!
 
Alanray,

I have my display set for min/secs and have no problem....I'll check it out and get back to you ASAP.....
Later Bruce
 
Alanray,

Finally got that checked out. Before you make a new program, you have to go into setup, under "offset type" and pick the ABS setting, not the bar setting. Once you pick the bar setting, all new songs will be in the bar mode not mun/sec mode. I have several songs that were created that way and I cannot change them over, they will always be in the bar mode.

Later
Bruce
 
Alanray,

Again, I learned something new......hold the shift key and the display select key and you can jog through the time settings...
Later
Bruce
 
You must log in or register to reply here.
Back
Top