AMp removes noise floor?

  • Thread starter Thread starter frankcvo
  • Start date Start date
F

frankcvo

New member
I currently use a TASCAM USB 122 , USB plugged into the PC, with a studio mic. There is a lot of noise floor. Would an pre-amp help?
 
I heavy never used the TASCAM USB 122, but from what I could find online, it does not have built in pres. What your running into is most likely the distortion caused by putting a mic level (-30 to -60dbm) signal into a line level input (+4dbm). Where a pre-amp will benifit you is by properly converting the mic level signal to line level. I am also guessing that since you are not using a pre-amp, you have to have your gain up super high to get a decent signal. Once again it is because the TASCAM USB 122 is expecting a line level signal and getting a mic level signal (creating even more noise for a improper gain structure).
 
phriq said:
I heavy never used the TASCAM USB 122, but from what I could find online, it does not have built in pres.
Click to expand...


You probably can't find it cos it's US-122 not USB-122.

It has two mic preamps with phantom power.

Frank, i can wholeheartedly recommend the presonus audiofire module for clean mic preamps with a lot of gain.
 
Also, check your internal operating levels..( ie.. -10 and +4 )..Good luck
 
If you are getting excessive noise from the Tascam, you have something set up wrong or another issue. Even the most basic interface nowadays gives a reasonable quality.


alan.
 
I have XLR from the mic directly to the Mic in. As someone else mentioned, I have to turn the gain all the way up in order to get a decent volume. If phantom power is on, the volume is higher, but so is the line noise.
 
What kind of mic?

Have you tested it with another interface?
Have you tested your interface with another mic?
Have you tried a different cable?
 
Something going on with the mic or cable, if the mic needs phantom it won't work with it off, if the mic does not need phamtom it won't make any difference if it's on or off.

As asked above, what is the mic, is the cable a proper mic cable with 2 cores and a shield (not a guitar cable with a XLR on the end).

Alan.
 
what kind of noise, electrical noise or room noise
How high is the noise floor?
 
You must log in or register to reply here.
Back
Top