Tascam DM 4800

  • Thread starter Thread starter Bugzee
  • Start date Start date
B

Bugzee

New member
I would like some Help Plz, with my DM 4800 I cannot figure out what's going on and this is driving me nuts.
the master fader is turn all the way up and the volume keeps trying to get loud
but it does not, when I try pushing the Layer Status it tend to get a bit loud but does not... PLZ HELP!!!!.
 
can u try be more specific about ur problem? i just cant understabd what is the problem.
how can the volume keep trying to get loud??
do u get signal? do u se movement on the meters?
"when I try pushing the Layer Status it tend to get a bit loud but does not..." < what u mean with that?
 
I would like some Help Plz, with my DM 4800 I cannot figure out what's going on and this is driving me nuts.
the master fader is turn all the way up and the volume keeps trying to get loud
but it does not, when I try pushing the Layer Status it tend to get a bit loud but does not... PLZ HELP!!!!.

Did you buy it used on e-bay,just wondering.........:yawn:
 
Did you buy it used on e-bay,just wondering.........:yawn:
Did you sell it on eBay?:laughings:

To Bugzee,
Is the project a new one, or is it one that was loaded from eBay prior to your purchase?
Maybe, try creating a clean project.
Also, please explain the rising in volume a bit better. Does any faders under any layer move during the rise in volume?
In your DAW project, check that there is no Automation. Again, try to create a clean project in Cubase, Logic, etc.
Let us know of your findings
 
When in doubt, re-init......Press SHIFT + ASSIGN 1 + ASSIGN 2 while switching power on. This brings you into diagnostics menu, where you can initialize the DM.
 
Back
Top