M
mikgag
Guest
Right now I record my band live off the floor (always, no tracking) and get pretty decent results. However, being musician/hobbyist/gear-whore I'm always looking for better. My current setup is as follows:
Mackie CR1604 (not vlz, not pro, the original)
I use 10 channels
channels 1-3 (XLR w/pre) = vocals (lead + 2 backup)
channels 4-5 (XLR w/pre) = guitar1, guitar2 (both cabs mic'd with 57's)
channel 6 (XLR w/pre) = overhead (modded MXL 603)
channel 7 (1/4 unbalanced line) = kick (D112)
channel 8 (1/4 unbalanced line) = snare (57)
channel 9 (1/4 unbalanced line) = tom (57)
channel 10 (1/4 unbalanced line) = Sansamp bass DI
I then run 2 1/4 to rca cables from the "mains out" into an Audiophile 24/96 card and record in Soundforge.
Question 1: Would swapping the mixer with a PV14 or Yamaha MG12 make a significant difference (the "wet blanket off the speakers" kinda difference) since I'd have all channels using bal XLRs w/pre's + rca tape outs and I'm sure a few other improvements(better pre's?).
Question 2: Whether I change mixers or not, since I record everything live down to to a stereo track, would putting an outboard compressor in front of the kick and snare be beneficial to add punch/level control?
Sorry for the long winded (cross)post....
Mackie CR1604 (not vlz, not pro, the original)
I use 10 channels
channels 1-3 (XLR w/pre) = vocals (lead + 2 backup)
channels 4-5 (XLR w/pre) = guitar1, guitar2 (both cabs mic'd with 57's)
channel 6 (XLR w/pre) = overhead (modded MXL 603)
channel 7 (1/4 unbalanced line) = kick (D112)
channel 8 (1/4 unbalanced line) = snare (57)
channel 9 (1/4 unbalanced line) = tom (57)
channel 10 (1/4 unbalanced line) = Sansamp bass DI
I then run 2 1/4 to rca cables from the "mains out" into an Audiophile 24/96 card and record in Soundforge.
Question 1: Would swapping the mixer with a PV14 or Yamaha MG12 make a significant difference (the "wet blanket off the speakers" kinda difference) since I'd have all channels using bal XLRs w/pre's + rca tape outs and I'm sure a few other improvements(better pre's?).
Question 2: Whether I change mixers or not, since I record everything live down to to a stereo track, would putting an outboard compressor in front of the kick and snare be beneficial to add punch/level control?
Sorry for the long winded (cross)post....