VST to control panning inside a stereo track

  • Thread starter Thread starter AdamZuf
  • Start date Start date
A

AdamZuf

New member
Hi guys,
I mix with Nuendo, and I usually process both overheads the same way, but of coarse the panning change. I prefer to have the OH in a stereo track but with an insert to control the panning of each track, too bad it ain't in the mixer like PT.
Is there a free plug that can do that?

Thanks
Adam
 
You can automate the panning of a stereo track with Cubase, I would assume Nuendo to be the same.
 
What does it has to do with automation?
I want a plug that will have a pan control for the left channel and the same for the right channel, it's a "repan" action, to be more specific.
 
AdamZuf said:
What does it has to do with automation?
I want a plug that will have a pan control for the left channel and the same for the right channel, it's a "repan" action, to be more specific.
Click to expand...

What does your NUENDO manual say about that?
 
Sounds like you might have to just link two mono channels together for your overheads. What you are asking for is more of a dual mono operation than a true "stereo channel" operation.
 
RAMI said:
What does your NUENDO manual say about that?
Click to expand...

You are right. I should have checked, it's just that I never seen anyone uses this option and I also participated in a Cubase coarse in my school but it was never tought.

Thanks
Adam
 
Always use mono tracks and send them to a stereo buss. That will take care of all the issues and not take up more CPU cycles with extra plugins.
 
Ir won't allow sending to previous groups. I still want control over the whole kit in a fader. Second, because of Cubendo's stupid routing method, I use group channels for effects, and FX channels for reverbs, so I can send the effects to the reverbs, so again, it doesn't fit.
 
You must log in or register to reply here.
Back
Top