Tascam M520 PSU Cable - Connectors

  • Thread starter Thread starter Starliner
  • Start date Start date
Tascam told me years ago it was 20-conductor 20AWG stranded multi-conductor cable without shield. You can do with less conductors if the wire gauge is bigger.
 
Starliner said:
I FOUND IT! The missing PSU cable!

In a massive cleanout and reorganization, the cable was found packed away safely in a bag, but had gotten separated from the M-520 and the PSU. Probably it went missing over nine years ago.

I think I will hang it from the dining room ceiling light until it is connected into the system... don't want it to disappear!!!

Starliner
Click to expand...
Hello I too am in need of a cable.
I did find the connectors at Mouser but I need to know the wire gauge. Can you look at your cable and see if you can read any writing on it? That would have the wire gauge? It should say AWG and then a number - another number. Thx
 
pbhsnd said:
Hello I too am in need of a cable.
I did find the connectors at Mouser but I need to know the wire gauge. Can you look at your cable and see if you can read any writing on it? That would have the wire gauge? It should say AWG and then a number - another number. Thx
Click to expand...

Right here is your answer from only one post before your posting. :-)

sweetbeats said:
Tascam told me years ago it was 20-conductor 20AWG stranded multi-conductor cable without shield. You can do with less conductors if the wire gauge is bigger.
Click to expand...
 
Has anyone had success in wiring up a duplicate PSU cable yet for Tascam M 520?

This is to be the centerpiece of our small family owned studio. We are without a cable after a long process of even obtaining the mixer itself.

Hoping to find a cable, or someone who could wire up a cable. We need this mixer up and running. Thank you all. I realize this is an old thread.
 
You must log in or register to reply here.
Back
Top