Hey guys. I have a new fender amp on the way to work in tandem with my Laney. The Laney has a DI out routed through a torpedo cab, then straight to the interface. The fender will require a torpedo captor load box.
Here's the thing, I want both amps to share the same pedals and a single Torpedo Cab unit for selecting cab sims. They won't be used simultaneously; I just want to be able to switch between them.
Am I going about it the right way with this signal flow or is there a better way? I may substitute the '2 in 1 Out Switcher' for 3 inputs to allow from an extra amp later down the line.
Guitar...last pedal out (mono)...a/b splitter....
Path A OUT: To Laney
Path B OUT: To Fender
Laney DI OUT to '2 in 1 Out Switcher' INPUT A
Fender SPEAKER OUT (8ohm) to Torpedo Captor -- Captor out to '2 in 1 Out Switcher' INPUT B
Single output of switcher to Torpedo Cab ---- to focustite interface.
Here's the thing, I want both amps to share the same pedals and a single Torpedo Cab unit for selecting cab sims. They won't be used simultaneously; I just want to be able to switch between them.
Am I going about it the right way with this signal flow or is there a better way? I may substitute the '2 in 1 Out Switcher' for 3 inputs to allow from an extra amp later down the line.
Guitar...last pedal out (mono)...a/b splitter....
Path A OUT: To Laney
Path B OUT: To Fender
Laney DI OUT to '2 in 1 Out Switcher' INPUT A
Fender SPEAKER OUT (8ohm) to Torpedo Captor -- Captor out to '2 in 1 Out Switcher' INPUT B
Single output of switcher to Torpedo Cab ---- to focustite interface.