Hmmm.... I usually just copy the pic from photobucket and past it with other BB's and it shows up ......automatically puts the "" tags on it...??
Lets try this..
[img]https://img.photobucket.com/albums/v638/Savemaker1/IMG_1051.jpg
Here's the deal with my strat....
It originally came with the S-1 switching and the cobalt noisless. Well that's a pretty versitial set up, but not what I was looking for as I had my eye's on some Lindy Fralin Vintage Hots

So I bought them, and then had the pickguard made through Warmoth. I had them just cut the slot and hole for the 5 way and leave the rest solid since I wanted a "custom" knob placement.
I basically have just one volume knob (Closest to the strings/bridge) and one Blend knob - This knob blends in either the bridge or neck pickup on positions 1&2, and 4&5. This makes for some great tonal combinations!! Now here's where things get tricky!.......
I purchased the Lindy's pre-wired from ACME Guitar works (
http://www.acmeguitarworks.com/index.aspx ) and in the conversations I had with them about only using a two knob set up, they strongly recomended not removing the tone pot since even it it's turned all the way up, it still effects the tone of the guitar. So here's what I did.....I had them wire in the tone pot, but I put it in the position of where the volume pot would normally be, then I put the actual volume pot in the middle, and then the blend pot on the bottom........but you say "I only see two knobs/pots???"
I turned the tone pot all the way up and cut the shaft off of it. I then wrapped it in electrical tape and "hid" it under the pickguard.
Why did I do all of this??? In a nut shell, I've always had a problem of "bumping" the volume pot during playing and inadvertently lowering the volume a bit. This used to bug me to no end! So know I've got plenty of room between the bridge and the first knob to keep me from doing any "bumping"!
I've also done one of my other guitars like this as well:
Rick