Mpc Setp Up Help

  • Thread starter Thread starter tmay
  • Start date Start date
T

tmay

New member
I know this subject have been covered before but I don't quite understand. Ok when you are making beats with the akai mpc 2000xl do you make the beat then dumb it into a software, ie cubase, cakewalk. Are do you make each track go straight to the software
 
i'm just getting into cubase and my mpc is in the shop so this is an assumption.

I'd assume you'd use the mpc as a controller midi in, then route the midi out signals back to the mpc. Play your pads on to cubase midi tracks as you would normally with the mpc's seqencer. when you got what u want. record the tracks as audio back into cubase

Once again I havent had the chance to try this. also this is if you want to the sequence to be synced with any midi parts youd want to add.

other than that im sure you could just record it straight thru. if youre using one stereo track just make sure u mix it as well as you can in the mpc before recording it into cubase


if i'm wrong, someone pleez help out. I'm bound to run into the same question when i get my mpc back
 
Back
Top