J
Jamal
New member
I have modules in midi channels A and B of my MPC 2000. But the problem is when i change from A to B the volume changes from 127 to 100 on that module. What do i need to change?
Chriss
Jitens Half Brother
eich... not this again... can't remember what to do...
subtractor
New member
Sounds like you need to find the volume control parameter for the channels...
Chriss
Jitens Half Brother
subtractor said:
no.. i think it's a bit more complicated then this... arch... tried a similar situation once... it's kind of like a bug in the mpc, but it isn't
(sounds very sensible, right? )even though the channel B is already on 127, it will slide to 100 on the gear when you plug it in, am i right?
Chriss
Jitens Half Brother
ok...
Either your gear is set up to recieve midi on specific channels, which would mean that when you shift to B, it's expecting data from one specific channel but you've set up the wrong one for the output...
otherwise it's because you need to assign different channels to each gear (no overlaps!) because they recieve midi data on any channel sending. That means that when you go messing with channel A, channel B still gets input.
assign channels 1-8 to A and channels 9-16 to B or something similar...
my guess is that it's the last situation...
Either your gear is set up to recieve midi on specific channels, which would mean that when you shift to B, it's expecting data from one specific channel but you've set up the wrong one for the output...
otherwise it's because you need to assign different channels to each gear (no overlaps!) because they recieve midi data on any channel sending. That means that when you go messing with channel A, channel B still gets input.
assign channels 1-8 to A and channels 9-16 to B or something similar...
my guess is that it's the last situation...