Monitoring the signal paths

  • Thread starter Thread starter walters
  • Start date Start date
W

walters

New member
Monitoring the signal paths


Where can i Monitor the Signal paths

the Aux outputs and inputs?
the Buss lines?
The series inserts inputs and outputs?
the master faders?
Pre Fader monitoring?
Post Fader Monitoring?

These 8 Monitor Signals do i hook these to a patchbay A/B/C/D/E/F BOX hooked up to headphones to do this?

I know engineers have to Monitor the signals for recording good signals how do i do this like a real engineer?

Monitor off of the Power amps ?
how do i get to record the line signal coming out of the 100 watt power amp ?

I heard you get Compression from a power amp?
 
walters said:
These 8 Monitor Signals do i hook these to a patchbay A/B/C/D/E/F BOX hooked up to headphones to do this?
yes, but you need a Z-box for maximum flexibility, not just an F-box.... :rolleyes:

walters said:
I know engineers have to Monitor the signals for recording good signals how do i do this like a real engineer?
You already ARE an engineer, idiot -- this walters character is someone you cooked-up for shits 'n giggles, remember? :rolleyes:

walters said:
Monitor off of the Power amps ?
how do i get to record the line signal coming out of the 100 watt power amp ?
Route the speaker outputs back into a monitor input on your mixer, and make sure you crank the level all the way -- if you see sparks, that's normal - it just means that you're maximizing your signal level... :rolleyes:

walters said:
I heard you get Compression from a power amp?
Sure can, if you consider "clipping" to be compression...... :rolleyes:


Now shove-off, idiot -- your charade is done... hope you had some laughs......... :rolleyes:
 
Last edited:
Are the signals -10, +4,+6,+9 where at in the signal path Monitorings ?
 
Can I sell you some nanowebbers? They're still in the box!
 
Back
Top