Hi everyone. I've been tinkering around at home for years and thought I'd seek out some advice for my setup. Any suggestions would be appreciated. Here is the my current list of equipment, I'll explain my current setup momentarily.
Beheringer Eurorack UB2442FX-Pro mixer
Zoom RFX-2200 Digital Reverb
Zoom 9030 Multi Effects unit
Beheringer EX2200 Multiband Exciter
Behringer MDX 2600 Composer Pro XL Compressor
Behringer NR 300 Noise reducer pedal
Pedal board with random distortion pedals
The pedal board runs into in of the NR300, then out of that in to the in of the Zoom RFX and out to channel 2 on the mixer. The Exciter is using the ring tip to the composer, which uses the side chain into the send/return of the mixer (I'm not sure if that's the best configuration of those components). I have a PC plugged into channel 2 of the mixer as it controls an Axiom 49 keyboard. Channel 3 is used or clean bass, channel 4 is a Roland MC-303 groovebox, channel 5 is the Zoom 9030. What I was thinking was that the Exciter/Compressor/9030/NR300 could all be wired together to use the send/return component of the mixer. I just don't know what the best way to do that would be. Again, any help or suggestions are welcome. Thanks!
Beheringer Eurorack UB2442FX-Pro mixer
Zoom RFX-2200 Digital Reverb
Zoom 9030 Multi Effects unit
Beheringer EX2200 Multiband Exciter
Behringer MDX 2600 Composer Pro XL Compressor
Behringer NR 300 Noise reducer pedal
Pedal board with random distortion pedals
The pedal board runs into in of the NR300, then out of that in to the in of the Zoom RFX and out to channel 2 on the mixer. The Exciter is using the ring tip to the composer, which uses the side chain into the send/return of the mixer (I'm not sure if that's the best configuration of those components). I have a PC plugged into channel 2 of the mixer as it controls an Axiom 49 keyboard. Channel 3 is used or clean bass, channel 4 is a Roland MC-303 groovebox, channel 5 is the Zoom 9030. What I was thinking was that the Exciter/Compressor/9030/NR300 could all be wired together to use the send/return component of the mixer. I just don't know what the best way to do that would be. Again, any help or suggestions are welcome. Thanks!