D
dejacky
New member
I tried a positioning that sounds quiet good. Hopefully, it's not only because of my insane diligence to tuning my bass drum to sound "acceptable"
. Using my AT3035 mic about 3inches away from the kick drum hole but pointed towards the center of the resonant head. The -10dB pad is engaged without lowcut
. Overall, it really adds some "meat" to the sound whereas before it didn't capture those nice rich overtones and lower mids. It sounds better than the Shure SM57 3inches directly in front of the sound too!
.
What else do you all do?
I'm using a Pacific FS (birch) drumset with Aquarian Superkick I batter head and resonant head. Also use an Evans kevlar falam patch on the batter side. I decided to use my AT3035 mic because it was the only mic that could capture those low frequencies better..that's also why I didn't use the lowcut filter.



What else do you all do?
I'm using a Pacific FS (birch) drumset with Aquarian Superkick I batter head and resonant head. Also use an Evans kevlar falam patch on the batter side. I decided to use my AT3035 mic because it was the only mic that could capture those low frequencies better..that's also why I didn't use the lowcut filter.