Firepod outputs

  • Thread starter Thread starter dturcotte
  • Start date Start date
dturcotte

dturcotte

New member
OK guys... be gentle...

I have 2 pods presently and am about to add a third. I have basically just recorded through the pod and have not used the outputs at all (except for monitoring).

Here's my question, and again, please be gentle :)

I use a Behringer MX9000 as a mixer prior to input on the pod. And I usually just "mix in the box". But what i would like to do is come back out of the pod and back into the "mix B" section of the Beri on channels 25-48. I would just like to play with the idea of mixing through the mixer and see if I like it or not.

So, the question is, if I have 3 pods, do i just connect the outputs of all three pods to the designated input of the mixer and then route my ouput as necessary? Also, do i just select the track(s) and send to say bus1, bus 2, bus 3, etc...?

Let's say I get that far, what would be the best thing to mixdown to? CD Recorder? Dat? Or should I just route the main output of the mixer right back into the pod?

Thanks in advance for your help...
 
That's pretty much about it. Route each track output to Out1 left, Out1Right, Out2left.....etc.

The route the main outs from the mixer back into the firepod and record on a stereo track in your daw
 
You must log in or register to reply here.
Back
Top