Error 02

  • Thread starter Thread starter mncheetah
  • Start date Start date
M

mncheetah

New member
I just purchased an ADAT LX-20 from someone on Ebay. I bought a brand new high-quality tape, power on the ADAT, insert the tape, after a few seconds, "ERROR 02", pops up on the display, and it spits the tape back out. Does anyone know what this means? Did I get a faulty ADAT - there is only 110 hours on it.
 
Here's what it says in the appendix in my manual:

"Er 1 - Er 4: Tape Threading - These error codes are usually related to tape threading. Eject the tape and load it again. If this error message is displayed with only one tape, the cassette may be at fault. If the message is displayed with several tapes, with and without labels, you should contact Alesis for service."

Hope that helps ... if you don't have a manual ... you can get one online at:
http://www.alesis.com/downloads/manuals/adatlx20_man.pdf


Good luck ...
 
You must log in or register to reply here.
Back
Top