Dad Roadie
New member
I recently purchased one of these units to use with my Boss studio. (see attachment) Got it off EBAY . The seller didn't know if it worked and of course it did not. Found out that one of the wires (green one) had broken off from the small circuit board just behind the mic cartridge. The mic is an electric condenser that runs off a AA battery (kind of like a Shure BG4.1.Got a Engineer guide from EV but the schematic isn't to much help. I believe I got it back in the correct spot but the unit even though it now works doesn't have a lot of volume. I know its 150 ohms unbalanced low impedance but it is no comparison to the Shure BG4.1 that I also use..
I have two questions that I hope the forum may be able to help with.
1# does anyone have one of these microphones to look at the circuit board to see where the green ,red and white wire are attached? I can supply a photo of mine if necessary.
2# has anyone used one of these before? I record a lot of different percussion instruments for clinics that I give at our local schools to get kids involved with music and recording. Is this mic a dud for this ? I have not seen one of these listed before and bought it a lot on EV quality.
Any help or suggestions for recommendations are most welcome.
Thanks in Advance and All the Best!
Dad Roadie
I have two questions that I hope the forum may be able to help with.
1# does anyone have one of these microphones to look at the circuit board to see where the green ,red and white wire are attached? I can supply a photo of mine if necessary.
2# has anyone used one of these before? I record a lot of different percussion instruments for clinics that I give at our local schools to get kids involved with music and recording. Is this mic a dud for this ? I have not seen one of these listed before and bought it a lot on EV quality.
Any help or suggestions for recommendations are most welcome.
Thanks in Advance and All the Best!
Dad Roadie