J
Jack Real
New member
Hi
I just bought a TL Audio 5050 (Mono Valve Preamp & Compressor) and I want to check if my setting is correct. For the compression, I used the following parameters:
Threshold : -15 DB
Ratio : 3:1
Attack: .5 ms
Release: 40 ms
Knee: Hard
This might look too aggressive but that was the only way I could get 3 DB reduction on the peaks. Any suggestions on what I might do wrong ?
Thanks,
Jack Real.
I just bought a TL Audio 5050 (Mono Valve Preamp & Compressor) and I want to check if my setting is correct. For the compression, I used the following parameters:
Threshold : -15 DB
Ratio : 3:1
Attack: .5 ms
Release: 40 ms
Knee: Hard
This might look too aggressive but that was the only way I could get 3 DB reduction on the peaks. Any suggestions on what I might do wrong ?
Thanks,
Jack Real.