I am trying to run two sets of monitors using Sonar 2xl and a Delta 1010lt.
I'm not sure if I have the terminology right, but hopfully you can understand what I mean.
I have the main(A bus) going to one set and and the Main B bus going to the other set. By main bus I mean the sliders at the far right of the console view.
All tracks have their out set to main bus A and Aux Bus 1 swithed on to "post". Aux Bus 1 out is then set to Main Bus B.
I can hear music and adjust the levels on both of the mains with the appropriate result, but I can only hear pan settings applied to the individual tracks on the main A bus. Track pan settings have no effect on the mix going through the Aux Bus to Main Bus B.
Is there a way to hear the pan settings through both Main Busses?
I'm not sure if I have the terminology right, but hopfully you can understand what I mean.
I have the main(A bus) going to one set and and the Main B bus going to the other set. By main bus I mean the sliders at the far right of the console view.
All tracks have their out set to main bus A and Aux Bus 1 swithed on to "post". Aux Bus 1 out is then set to Main Bus B.
I can hear music and adjust the levels on both of the mains with the appropriate result, but I can only hear pan settings applied to the individual tracks on the main A bus. Track pan settings have no effect on the mix going through the Aux Bus to Main Bus B.
Is there a way to hear the pan settings through both Main Busses?