
cstockdale
supafly killa homey
I have a part in a song that is an organ (actually a modified preset in the Dreamstation synth), and one of the effects it is running through is a Revalver setup. I have set the EQ in it so that there is a low end peak, completely flattened out in the mids, and then a high end peak too. I would like to have the high end peak pan back and forth (ie sweep L-R at a set rate), but leave the low end peak where it is. How can I automate this effect? Do I need to use an EQ with a side chain to send the desired frequency range to an aux bus and then put a panning envelope on it?
Comprende?
Comprende?