Recent content by LuLu09

Hello everyone and hope you are all well. I was wondering about this tape speed issue...the fastest speed that my TEAC A-6010 will run is 7.5 IPS and according to what I've read on the web, 15 IPS is supposedly best ? Now then, I suppose this higher speed produces better audio specs, but what...

Thank You for helping me. I bought 2 new resistors from Digi-Key and it did the same thing. The thing that I'm the most bothered with is that until I moved the A-6010 into my home recording studio and tried to interface it with my Roland VS2480 and the Sampson "C" Controller (audio distribution...

Thank You for getting back to me. NO, the fuse does not blow...and when I lift the right side tension arm the capstan motor starts, but the 10 Ohm / 5 Watt wire-wound resistor starts to melt down, I mean really hot...I shut the A-6010 off immediately and this may be why the fuse doesn't blow in...

Hello everyone and hope all of you are well, I have a TEAC A-6010 that was working 100 % A-OK until I tried to connect it to my current recording system which basically consist of my Roland VS2480 and several pieces of outboard FX gear. I use a Sampson "C" Control unit which is basically like...

Hello again and hope everyone is well. OK bad bad news...My TEAC A-6010 that I recently had a couple of questions about just bit the dust. The recorder and every function of it was performing very well while connected to my 70's Pioneer receiver and my JBL 3 way speakers with a 12 inch woofer...

Once again many THANKS for helping me. Yes I totally agree the deck laying flat is optimal. Stay well, Charles

Hi Rich and thank you again for your help. Yes I saw this info today when looking at my manuals. The question is, what does -2dB translate to in regards to mV output ? While I'm here with you, maybe you can answer another question about my TEAC A-6010...I've read that operating / using a...

Again many thanks and OK I'll pay strict attention as to how hard I hit the INPUTs on the A-6010, Stay well, Charles

Thank You so much for helping me with this. I had the same idea rolling around in the back of my brain, but since I've tried something like this I thought I better error on the safe side and ask one of you guys what you think. And yes I have a small mixer that I can make this happen with :)...

Charles again...BTW what does RRuskin mean by the "OP" might not be ? Does this stand for Operating System ? Output ? Thanks :)

Thank You both for helping me with this. I'll be hooking this up this afternoon and will report back. In regards to "dropping the output to something that the Roland VS2480 can more easily handle"...how would I accomplish this ? Would I need to buy some kind of step down transformer gizmo...

Hello again, As I mentioned in my last post I picked up a mint condition ($10.00 total cost barn find) TEAC A-6010 RTR recorder and I'd like to know if I can use it with my current home recording set up. I'm using a mid 90's Roland VS2480 Digital Recorder and I'd like to know if and how to...

Hello, I just picked up a TEAC A-6010 RTR recorder but need to know what I should use for microphones ? Can I use my Shure SM57 dynamic mics with an impedance adapter resulting in the necessary 1/4 inch mono input plug on the end to connect to the A-6010 ? My TEAC A-6010 owners manual says...