Adding EQ, reverb, etc during mixdown?

  • Thread starter Thread starter Deaaaath
  • Start date Start date
D

Deaaaath

New member
Hey- here's a sort of dumb question but...
When mixing down from my Tascam 38 through my Teac 3 mixing board, can someone tell me how I can add reverb and EQ to the vocal track?
 
Deaaaath said:
Hey- here's a sort of dumb question but...
When mixing down from my Tascam 38 through my Teac 3 mixing board, can someone tell me how I can add reverb and EQ to the vocal track?
Click to expand...

Do you have the manual? It's all spelled out in there. Quick answer: Model 3 aux out (the 8X2 submixer section) to the input of any signal processor of choice. Output of processor to the aux return (or whatever the have called it) of the model 3. Note: each submixer pot is Tape/Pre/Post switchable. The position used depends on how you want to send to the signal processor. Tape = directly from the tape machine return path. (Input switch/ fader/eq have no effect. Post = signal to processor is fader/eq dependent. Pre = signal follows input switch but not fader/eq.

EQ is on the individual input modules. Set them according to taste.
 
You must log in or register to reply here.
Back
Top