Wiring for EV 4 pin mics

[Angusdevil]

Anybody know the wiring order for a Ev 4 pin connector to XLR?

 

[The Garage]

i was messing with this yesterday: the white is ground, the red and blue (or was it green) are for balanced. the other one is yellow, right? that one is the high impedance, i believe. easiest way to doublecheck is to get some mini-jumper cables and connect the various wires to an XLR's wires and see how it sounds.

 

[Angusdevil]

Thanks for the info. In my 664, it was a blue wire. I would assume this would be the same for Midland, DuKane and Calrad mics too? The reason I ask that because I also have a Midland 22-211 that looks like its wired for low-z but the switch is only a two position switch instead of the EV 3 way switches. I'm gettin very very low signal out of it and was thinkin maybe someone wired it wrong or forgot to change it over when they took the 1/4" plug off and put on a XLR. Would the mic still work properly if it was wired Hi-Z on the switch to XLR or is it something else with the mic?