Volume of mic

  • Thread starter Thread starter romeo_montaque
  • Start date Start date
R

romeo_montaque

New member
The input mic sound is picking up very low, how can i raise the db meters?
 
You will need a mic pre-amp to amplify the mic signal before it goes into your soundcard.
 
actually...

(judging by your post amount)

Go to Windows Recording Mixer.. either directly From CoolEdit's "Settings" Tab in Multi track,

or from Control Panel, where its listed as "Sound" or something...

even on the bottom right toolbar, there may be a spearker icon..


well..once in that..

click the "Recording" Tab..

and select microphone...

There should be an "Advanced" Tab...

In there there is an option for "Mic Boost"

which boots your incoming signal by +20 db...

hope this helps...

(Rep point what?!?) :D
 
crispycutz said:
:eek:

when did your rep turn to "3"?!?!?!?!
Ill take it that you are talkin to me since mine is the only one in the thread at 3 :) ...well..um...i dunno...i think on this past Wed. when someone put me over 100 points. How are you a senior member and i have been in a whole month longer than you!!! :)
 
Back
Top