very stupid question on vocals

  • Thread starter Thread starter dumass
  • Start date Start date
D

dumass

New member
im using EV cobalt 7 through a behringer mx2004, into the delta 1010, into sonor. the problem is when i record the vocals, then seem to stick out a lot, and seem to be very thin.

now here comes the questions....
1 - do i jus need a better mic? or preamp (such as the audio buddy, or wats the best for about $150 or less???)
2- i also have a shure sm57...should i be using that? im also going to get the octava mc012 for overheads, should i use that when i get them, or should i get another mic jus for vocals?
3 - if so, whats the best mic for vocals (a condensor) for about $150 or less?
4 - is it jus the eq-ing?

sry for asking so many questions...but im very confused on this...
 
I don't know of any nice condenser microphones for under $150.

I'd say your best bet is the 57.
 
how bout something like the studio projects b1 or something liek that?
 
im gonna try out that sm 57 on vocals...now do u think i should upgrade the mic pre, or the mic, if anything??
 
I don't know what is that you want in a vocal track or what kind of music do you sing, but these guidelines have worked for me.

a) Try the SP B1 for those vocals. I don't know, but it seems your EV is a dinamic mic, that generally is not suited for vocals.

b) Try the Audiobuddy too, it should make a difference

c) Try compressing the vocal track.

d) Cut all frequencies below 80 hz

More info about your music would be good.
 
It's known that running dynamic microphones through Mackie and Behringer pre's will typically make the mike thin and harsh sounding compared to superior pre's.
The Oktava MC-012 (or MK-012) SD condenser can work well on a vocal. If you're going to Guitar Center and the like, it's a good idea to ask to go through a bunch of microphones until you find the one you like. They can vary greatly in tone and/or don't work at all! If you find a nice one it'll go better with the Behringer pre's
than the dynamic microphones you have.
As with any mike, you need to get a mesh pop screen to properly record your vocals.

If you'd like to use your dynamic microphones for vocals, consider getting the Studio Projects VTB-1. It's $129 at www.digitalproaudio.com
The sound of a SM57 can be varied by selecting either the "50 Ohms" or "200 Ohms" impedance switch BTW, and it seems the 50 Ohms setting makes it sound "thicker".

There's a planned revamp of the Joe Meek line in the works.
Using a Meek compressor will also "thicken" your vocals.

Chris
 
Also, sorry if this seems too basic, however, sometimes singing closer to a unidirectional microphone (like a cardiod SM57),
will also help.

Chris
 
An sm58 will also help thicken up you vocals, and ad a nice warm bottom the closer you get to it. I believe you can buy a "ball" windscreen that "converts" the 57 to a 58.
 
Back
Top