Traveler and Tascam FW1804 connected with adat optical

[DrOnion]

Hello. I am trying to record using my MOTU Traveler and a friend's Tascam FW1804 connected with an adat optical cord. FW1804 adat out into Traveler adat in. Sonar 5 and the Traveler Cue Mix console will find all the adat inputs. However, the Traveler is only sending a stereo signal to SONAR. I can get a signal from all 8 analog inputs on the FW1804 into the Traveler, but the Traveler is only sending them from ADAT 1 and ADAT 2 to Sonar. The Traveler Cue Mix console lists all 8 ADAT inputs, but the signal from the odd inputs (1,3,5,7) on the FW1804 are on ADAT 1 and all even inputs are on ADAT 2. Should I be getting an eight channel send out of the Traveler? I'm hoping to be able to record these on seperate channels.
Thanks.

 

[petermiller]

the traveler has both toslink and adat optical. are You using the right one? check to make shure

 

[dgatwood]

the traveler has both toslink and adat optical. are You using the right one? check to make shure

Yeah, this sounds like what would happen if it were sending S/PDIF instead of ADAT protocol.