K
kivelo
New member
I just bought a TASCAM 788 via eBay (the item was in perfect, near mint condition with original packaging, cables and manuals and from a buyer with 100% positive feedback, so good vibes there) and despite everything appearing to work fine I have a small issue I'd like to bounce off you folks in this forum.
I started using it last night for the first time and while playing around with some of the pre-set effects the LCD menu display suddenly went blank, clean as a fresh slate. I turned the contrast knob a few times and it came back. But after a short time it went blank again.
I powered off the unit, powered it back on, and everything seemed great, the display lasted until I was finished with my session.
This morning I powered it on and after a couple minutes it went blank again. I did the power off, power on, and this time left the contrast knob in the halfway position instead of almost full, as it had been. The display lasted until I was finished this time.
Question: is there a known issue with the menu display going blank and is this indicative of a growing problem I will need to have looked at? The TASCAM site has no troubleshooting for the LCD and of course the forums there are toast.
Any help/advice/info appreciated.
Thanks guys!
kivelo
I started using it last night for the first time and while playing around with some of the pre-set effects the LCD menu display suddenly went blank, clean as a fresh slate. I turned the contrast knob a few times and it came back. But after a short time it went blank again.
I powered off the unit, powered it back on, and everything seemed great, the display lasted until I was finished with my session.
This morning I powered it on and after a couple minutes it went blank again. I did the power off, power on, and this time left the contrast knob in the halfway position instead of almost full, as it had been. The display lasted until I was finished this time.
Question: is there a known issue with the menu display going blank and is this indicative of a growing problem I will need to have looked at? The TASCAM site has no troubleshooting for the LCD and of course the forums there are toast.
Any help/advice/info appreciated.
Thanks guys!
kivelo