signals in Patchmix and Cubase LE don't match

[thanhkim]

Hey Guys...

I have my Cubase LE and my Patchmix DSP (for the EMU 0404 soundcard - not USB)... the signal that is being read in Patchmix is at a good level... around -20. BUT... the signal being recorded in Cubase is minimal. I can hardly see it make a dent.

But since it is direct monitor, isn't the signal being read on the Main Mix of the Patchmix the actual signal of the song?

I am not sure which level to look at, and I dont' understand why they don't match up.

 

[TimN]

First off, I would say that the -20 db level is a bit low--try to get it up to the -10 db level. I have the same sound card, but I don't use the Cubase LE, and I've heard similar complaints about the Cubase (I use Magix). Try sending the signal through the AUX sends in Patch mix--this will allow you to boost the signal going into Cubase considerably. Don't overload it, though.
Another thing: If I remember right, you can't direct monitor with Cubase LE and Patchmix. I read all the instructions to Patchmix, and I do remember something about this. My advice would be to print the instruction manual for Patchmix and read it, paying special attention to the part about setting up Cubase LE.