D
dreib
Active member
So a buddy of mine has a crap load of this stuff, its a about 3-4 foot long and all 2 inches thick.
We cant decide if we should make those tube trap type absorbers or just cut some of it in half, stack it to get 4 inches thick, place them side by side, then stuff them in panels?
Obviously if we did that they would be wavey looking, if you know what i mean?
Any ideas?
To clarify what i mean by cutting them in half is from top to bottom so you end up with 2 half round pieces that would be 2' thick.
Hope this makes sense.
We cant decide if we should make those tube trap type absorbers or just cut some of it in half, stack it to get 4 inches thick, place them side by side, then stuff them in panels?
Obviously if we did that they would be wavey looking, if you know what i mean?
Any ideas?
To clarify what i mean by cutting them in half is from top to bottom so you end up with 2 half round pieces that would be 2' thick.
Hope this makes sense.