I got a Proline kit at GC that has pickup rings and hardware for two humbuckers.
When I tried to add a ring, the pickup adjustment screws screwed into the pickup's holes just fine, but then they pulled back up when I put tension on them.
They're just the tiniest bit smaller than the screw that came out of there. The holes aren't big enough to have been drilled out, so what gives?
Aren't pickup screw holes a standard size? And where would I find ones the right size?
It's an Epi SG, not positive where it was made.
When I tried to add a ring, the pickup adjustment screws screwed into the pickup's holes just fine, but then they pulled back up when I put tension on them.
They're just the tiniest bit smaller than the screw that came out of there. The holes aren't big enough to have been drilled out, so what gives?
Aren't pickup screw holes a standard size? And where would I find ones the right size?
It's an Epi SG, not positive where it was made.