OmniStudio and SONAR 2 XL Monitor problems

  • Thread starter Thread starter bluesdaddy
  • Start date Start date
B

bluesdaddy

New member
Hope someone can help me out.

I am using my Delta66/OmniStudio and SONAR 2 XL. I cannot get anything to come out of my monitors. I cannot hear anything when recording or playing back but in Sonar and on my Omnistudio breakout box it's showing that a signal is coming in.

Can anyone help me out in setting up this card with SONAR 2 XL?

Thanks
Lenny
 
Check your software mixer the"delta panel" it should be listed under start/settings/control panel it sound like you have the output muted
 
Nothing is muted. And as far as I can tell everything points in the right direction.

grrr....
 
bluespop - What is your routing from the soundcard to the monitors? Make sure that your "output" selection in Sonar is going to the stereo pair that your monitors are connected to.

Also, how is your Delta control panel configured. IOW, for the stereo pair that your monitors are hooked up to, what selection do you have (Wave Out, H/W Out, etc.?)
 
Bluesdaddy,

What kind of monitors are you using - and - has this setup ever worked for you with any other software? Or is this your first go at it.

First thing I recommend is make sure that Monitor Mixer is selected on the Routing Tab of the Delta Control panel. This caught me early on when I bought my Omni Studio.

Update when you can.

Cuzin B
 
You must log in or register to reply here.
Back
Top