M
MrPixar
New member
Hello All--
I have been trying to work our some of the kinks with getting my omni studio setup properly. I have run into something I am hoping someone has experience with because from my viewpoint the manual says one thing, yet I see another. Here goes...
I am recording two guitars (guitar 1 into MIC/INST INPUT1 and guitar 2 into MIC/INST INPUT2) to have preamp ability. The manual specifically states that on page 19 that "MIC/INST 1 .. Left PCM in 1/2 Delta and MIC/INST 2 .. Right PCM in 1/2 Delta..
So, when I look at the delta control panel I see both the left and right channel levels work as appropriate for this config in the H/W IN 1/2 Column (that matches the manual). However, the MASTER VOLUME has both inputs using the LEFT channel only? WTF?
So, in trying to monitor the signal I hear everything (the two guitars) blasting out of my left monitor only.
Please tell me someone has experienced this and can help me out?
TIA
/mp/
I have been trying to work our some of the kinks with getting my omni studio setup properly. I have run into something I am hoping someone has experience with because from my viewpoint the manual says one thing, yet I see another. Here goes...
I am recording two guitars (guitar 1 into MIC/INST INPUT1 and guitar 2 into MIC/INST INPUT2) to have preamp ability. The manual specifically states that on page 19 that "MIC/INST 1 .. Left PCM in 1/2 Delta and MIC/INST 2 .. Right PCM in 1/2 Delta..
So, when I look at the delta control panel I see both the left and right channel levels work as appropriate for this config in the H/W IN 1/2 Column (that matches the manual). However, the MASTER VOLUME has both inputs using the LEFT channel only? WTF?
So, in trying to monitor the signal I hear everything (the two guitars) blasting out of my left monitor only.
Please tell me someone has experienced this and can help me out?
TIA
/mp/