Multi-channel Preamps to soundcards

  • Thread starter Thread starter theNaturalists
  • Start date Start date
T

theNaturalists

New member
I'm looking at possibly getting a Delta 44 or Audiophile along with a DMP3/Audiobuddy. I'm new to multi-track recording hardware for computers and just wanted to double check and make sure that a 2 channel preamp can output to two different tracks on the soundcard. It does keep the outputs separate so each mic will be on its own track correct? I know this is probably a "duh" type of question, but i haven't been able to see a close enough pic of these preamps to see if each channel has its own output.

Also, are there any other soundcard/preamp combos you may suggest over what i've mentioned that would be around the same price range?
 
Yep, each preamp has its own outputs. You just connect each output to an input (left/right) of the card and that's it.

To record each input to a track, you need to consult the manual of your recording application. Almost all aplications let you chose what channel (left or right) you want to record on what track. (so, even if your card has a stereo input, you can use it as two mono inputs).
 
Alright cool, that's what I thought, but it doesn't hurt to ask.

I was also wondering if running phantom power to a dynamic mic could be harmful to any of the equipment involved. I'm wondering cause i was thinking about getting the Audio Buddy for my Delta 44. I only have dynamic mics now, but will probably get a condenser mic in the future. However, the Audio Buddy runs phantom power to both channels (they're not independent). Would having a condenser on one channel and a dynamic on another with phantom power turned on cause any problems??
 
"Most mics use a transformer as the output to the board preamp. A transformer won't pass DC. That's how phantom power works; they put +48 volts DC on pin 2 and 3 (relative to ground), and then the transformer stops it from going any further. But now they have that voltage at the mic and they can tap off of it to power the capsule and the electronics. Can it hurt a dynamic mic? Yes under a couple of conditions.

It could damage a mic if one side of the transformer or the cable is shorted to ground, or the connector doesn't make contact with both signal pins at the same time. For the most part, it shouldn't be a problem, but it's always a good idea (whenever possible) to turn off phantom power before connecting or disconnecting ANY mic.

Ribbon mics are most suceptable to phantom power since the ribbon acts like a fuse, and it will simply break or vaporize, but the transformer will usually offer some safety, even there."



https://homerecording.com/bbs/showthread.php?s=&threadid=27071&highlight=phantom+power+damage
 
ok, thank you very much for the link and good information!
 
You must log in or register to reply here.
Back
Top