V
Vurt
New member
I mix down from a TASCAM 424 into Wavelab, with a Yamaha rev500 loop. The problem is that the amount of reverb heard through the monitors (yamaha msp5's) is not accurate, although everything else is.
I have to set the reverb to a point so low that it's virtually inaudible through the monitors, but once on the pc, it's very clear. So basically, I have to sit there and guess what level to set the reverb. I've experimented with different combos of +4/-10 dB, but the same problem results with each.
anyone know what I'm talking about and have any ideas?
I have to set the reverb to a point so low that it's virtually inaudible through the monitors, but once on the pc, it's very clear. So basically, I have to sit there and guess what level to set the reverb. I've experimented with different combos of +4/-10 dB, but the same problem results with each.
anyone know what I'm talking about and have any ideas?