Mia Midi analog input tiny bit of signal at -10 setting nothing plugged in

  • Thread starter Thread starter Yasoo
  • Start date Start date
Y

Yasoo

New member
Can anyone with a Mia Midi verify if they get this Behaviour?: If I set the analog inputs to -10 and nothing is plugged in, the meters show a tiny bit of signal (about 3 to 5 pixels hi, less than -70dB). Is this normal?
 
I just installed mine this past weekend. Mine didn't do that...

I have pretty much zero feedback, unless I send a signal through it.
 
Plug in your monitors or headphones and turn the volume way up until you can hear the noise.

If it sounds like someone's low humming, you may have a 60-cycle hum from somethin not grounded right on the electrical circuit (anywhere from that wall plug back to the house circuit breaker box!) You'll have to go on a hunt to find it by unplugging everything until the sound goes away....
 
Back
Top