
ollie99
New member
Hi, this is urgent, I have a marshall mg50fx and the jack input has fallen inside the input hole. This has happened a few times before and I've fished it out with a skewer, but this time I couldn't get to it so I unscrewed the screws off the top and took the whole top bit out. I fixed the input and then when I slid it back in it wouldnt fit right. The bottom of it would fit in, but the top bit just couldnt fit right.
It was all the way in so it almost looks like it is fine, but the top bit just wont go any further so it is on a slight tilt and I can put the screws back in. HELP ME!
thanks
It was all the way in so it almost looks like it is fine, but the top bit just wont go any further so it is on a slight tilt and I can put the screws back in. HELP ME!
thanks