T
Tomm Williams
New member
Need one to pair with the one I have. Anybody want to part with theirs ?
E
ecc83
Well-known member
https://homerecording.com/bbs/equip...electret-cardioid-mic-model-33-1080-a-354890/
Been seen before ^ !
Phantom power is a no-no. Firstly because as the map shows, there are no "pickoff" resistors connected to pins 2 and 3 and then C1 is only rated at 25volts and I doubt that the FET "IC" has an onboard regulator.
9volts will in any case give a pretty healthy output. The big question is how much of the electret charge is still present?
That is a nice mic for a Realistic! Most of the stuff that came here under the Tandy banner was unmitigated crap!
Hey! Anyone remember "Eagle"???
Dave.
Been seen before ^ !
Phantom power is a no-no. Firstly because as the map shows, there are no "pickoff" resistors connected to pins 2 and 3 and then C1 is only rated at 25volts and I doubt that the FET "IC" has an onboard regulator.
9volts will in any case give a pretty healthy output. The big question is how much of the electret charge is still present?
That is a nice mic for a Realistic! Most of the stuff that came here under the Tandy banner was unmitigated crap!
Hey! Anyone remember "Eagle"???
Dave.
Attachments
T
Tomm Williams
New member
The phantom power comment is a surprise as I've used mine with phantom in the past. This one was made for RS by Sony so yes, it's much better than their usual garbage.
Wish
Never Sarcastic....Honest
I've got a 33-1090A that I will let go for $40 shipped USPS Priority. I'm not sure how different that is from tha 33-1080.
Can provide pictures if you want. It is missing the battery cover, but other than that, it's in great, working condition.
Can provide pictures if you want. It is missing the battery cover, but other than that, it's in great, working condition.
Wish
Never Sarcastic....Honest
E
ecc83
Well-known member
Well, I only have the forum's information that the Sony circuit is in fact the same as the Realistic. Then it would be fairly easy to modify a mic to use phantom power....
Assuming a safe 20volt feed to the FET and the source at 1/2 supply, the spook feed resistors work out at a very handy preferred value of 22k each. Mind you, that is taking big liberties as to the characteristics of the FET "chip"! Some experimentation would be in order.
Dave.
