I think my mixer just broke!

[JBr33zyMusic]

I have a Behringer Xenyx 1204Usb running into cubase. I finally got it working today and I recorded one verse. Then i noticed it was too loud so i turned some the gain down and all the faders. So then i started getting no sound from my mixer at all. I turned the gain and faders up but yet nothing. I played a beat through cubase and my mixer acted fine towards it. The meter was going up in down like it did with my voice. I cant get it working again. Does anyone have any advice?

 

[JimmyS1969]

Sounds like you should take it back and buy something that isn't a Behringer dood.

 

[Lt. Bob]

I have a Behringer Xenyx 1204Usb running into cubase. I finally got it working today and I recorded one verse. Then i noticed it was too loud so i turned some the gain down and all the faders. So then i started getting no sound from my mixer at all. I turned the gain and faders up but yet nothing. I played a beat through cubase and my mixer acted fine towards it. The meter was going up in down like it did with my voice. I cant get it working again. Does anyone have any advice?

I think it's gonna turn out to be a button pushed that shouldn't be or a wiring issue.
It's not common for a mixer to just suddenly break.

Start trouble shooting by plugging a mic directly into the mixer ( a non phantom powered mic if you have one) and plugging some headphones into its' headphone jack.
You should get some sound in the 'phones. If you don't then the mixer might be bad but I'm betting it gives you sound set up like that.
If it does give you sound .... then it's something to do with how you have it interfaced with the 'puter.

 

[mjbphotos]

Check the channel mute buttons, and that you have the channel send buttons pushed for the main mix.

 

[witzendoz]

Sounds like you should take it back and buy something that isn't a Behringer dood.

And buy something from the Chinese factory next door? Pointless answer from another Behringer basher.

 

[JimmyS1969]

I suppose my statement would come off that way. I had been working with the OP for two days through PM's trying to get his unit working. I had an issue with a Behringer mixer in the past and this was directed towards his situation and not a bash at all Behringer gear. I currently use an HA4700, and I'm not a Behringer basher. Just anti 'this' device that we couldn't seem to figure out.